HyperWorks is a high-performance, comprehensive toolbox of CAE software for engineering design and simulation.
HyperWorks is available to all OSC users without restriction.
The following version of Altair Hyperworks can be found for the following environments:
To use HyperWorks on the OSC clusters, first ensure that X11 forwarding is enabled as the HyperWorks workbench is a graphical application. Then, load the hyperworks module:
module load hyperworks
The HyperWorks GUI can be launched then with the following command:
For information on downloading and installing a local copy through the state-wide license, follow the steps below.
NOTE: To run Altair HyperWorks, your computer must have access to the internet. The software contacts the license server at OSC to check out a license when it starts and periodically during execution. The amount of data transferred is small, so network connections over modems are acceptable.
Usage of HyperWorks on a local machine using the statewide license will vary from installation to installation.
Click on "Login" in the upper right hand corner of the page.
If you have already registered with the Altair web site, enter the e-mail address that you registered with and your password and skip to step #5.
If you have not registered yet, click the link that says "Click here to register now". You will be prompted for some contact information and an e-mail address which will be your unique identifier.
IMPORTANT: The e-mail address you give must be from your academic institution. Under the statewide license agreement, registration from Ohio universities is allowed on the Altair web site. Trying to log in with a yahoo or hotmail e-mail account will not work. If you enter your university e-mail and the system will not register you, please contact OSChelp at firstname.lastname@example.org.
Once you have logged in, click on "SUPPORT" and then "SOFTWARE DOWNLOADS"
In addition to downloading the software, download the "Installation Guide and Release Notes" for instructions on how to install the software.
IMPORTANT: If you have any questions or problems, please contact OSChelp at email@example.com, rather than HyperWorks support. The software agreements outlines that problems should first be sent to OSC. If the OSC support line cannot answer or resolve the question, they have the ability to raise the problem to Altair support.
Go to this webpage: http://www.osc.edu/supercomputing/software/general.shtml. Download the HyperWorks form from the software list, fill out and fax to the number given on the form. License server information will be provided to you at this time.
In order to be added to the allowed list for the state-wide software access, please send the IP address/range of the machine that's going to run the software to OSChelp.
For more information about HyperWorks, see the following: